Equipment Regulation • ELDT.LIVE
FMCSA Seeks Comment on Camera System That Could Replace Truck Mirrors
Safety Vision is asking for a five-year exemption to let motor carriers use its View Smart camera-monitor system instead of the two exterior mirrors required by federal rules; FMCSA has not approved the request.
FMCSA opened the application for public comment
The Federal Motor Carrier Safety Administration published a November 18 notice requesting comment on Safety Vision, LLC's application for an exemption from 49 CFR 393.80(a). The company wants motor carriers to be allowed to install its View Smart camera-monitor system as an alternative to the two exterior rear-vision mirrors normally required on buses, trucks and truck tractors. The proceeding is Docket No. FMCSA-2026-3707.
This is a proposal, not permission to remove mirrors
FMCSA's notice does not grant the exemption, change the mirror rule or authorize a fleet to remove required mirrors today. The agency must review the application, safety analysis and public comments, then publish a separate grant-or-deny decision. Until an applicable exemption or other lawful authorization exists, carriers and drivers remain responsible for the current equipment requirements.
The existing rule requires two outside rear-vision mirrors
Section 393.80(a) generally requires every bus, truck and truck tractor to have two rear-vision mirrors, one firmly attached on each side and positioned to show the highway to the rear along both sides of the vehicle. The mirrors and their replacements must meet the applicable minimum requirements of Federal Motor Vehicle Safety Standard No. 111 in force when the vehicle was manufactured.
Safety Vision is requesting a five-year exemption
The company asks FMCSA to authorize the alternative for the maximum five-year period available under the exemption process. If granted as requested, the exemption would be available to motor carriers operating qualifying vehicles equipped with the specified View Smart system. The final scope, conditions, documentation requirements and effective dates would depend on FMCSA's later decision.
The system uses dual-lens exterior cameras and in-cab displays
According to the application summarized by FMCSA, View Smart uses a weatherproof dual-lens camera on each side of the vehicle. Video is sent to monitors positioned at the cab's A-pillars. Safety Vision says the system supplies both main and wide-angle fields of view and adjusts display brightness for changing light conditions.
The applicant claims wider coverage and additional alerts
Safety Vision says moving the viewing surface from exterior mirror housings to interior displays can reduce blind spots near the A-pillars, improve low-light visibility and reduce the chance of mirror damage. The application also describes visual outlines and audible alerts when pedestrians or vehicles enter detection zones. These are the applicant's claims; FMCSA has not yet made an equivalency finding.
The agency must apply an equal-or-greater safety test
FMCSA may grant the exemption only if it determines that the proposed alternative would likely achieve a level of safety equal to or greater than the level provided by compliance with the mirror rule. That review can include image quality, field of view, latency, weather performance, display location, maintenance, driver workload, electrical failure modes and the practical ability to detect a failed component.
Drivers would need training for normal use and failures
A camera-monitor system changes where a driver looks, how distance and closing speed are judged, and how a defect is recognized. Fleets considering any authorized system would need procedures for pre-trip checks, lens cleaning, monitor brightness, glare, condensation, wiring damage, fault messages and safe response to a blank, frozen or delayed image. An exemption would not remove the driver's duty to operate safely or report defects.
Roadside inspections would depend on the final conditions
If FMCSA grants the application, the decision would explain which vehicles and systems are covered and whether drivers or carriers must carry documentation. Inspectors would evaluate compliance against the final exemption terms as well as other applicable equipment rules. A product brochure, purchase order or pending docket would not substitute for an effective federal exemption.
Comments are due December 18
FMCSA is accepting comments through December 18, 2026, under Docket No. FMCSA-2026-3707. Fleets, drivers, instructors, inspectors, technicians and safety professionals can submit evidence through Regulations.gov. Useful comments should address measurable safety performance, real operating experience, training, inspection, maintenance and failure response rather than assuming that every camera system performs the same way.
The practical step is to preserve current compliance
Carriers should not change a vehicle's required mirror configuration based on the application alone. Continue inspecting and maintaining the existing mirrors, document any camera system already used as supplemental equipment, and wait for FMCSA's formal decision before treating View Smart as a replacement. If the agency grants the request, review the exact model, scope, conditions and expiration date before installation or dispatch.
ELDT trainees should learn both the rule and the technology
Entry-level drivers should understand that technology can supplement or, under a specific legal exemption, replace a required component without eliminating the underlying safety task. Training should still cover mirror adjustment, scanning, blind areas, lane changes, backing and defect reporting. For a camera-based system, add display interpretation and failure recognition—but do not assume a pending exemption changes the vehicle used for the CDL skills test or ordinary fleet operations.
Educational summaries help you prepare, but official FMCSA and state licensing sources remain the authority for current requirements.
Official sources
Federal Register — Safety Vision Exemption Application (FR Doc. 2026-23410) ↗Federal Register — Public Inspection PDF ↗Regulations.gov — Docket FMCSA-2026-3707 ↗49 CFR 393.80 — Rear-Vision Mirrors ↗49 CFR 381.315 — Exemption Application Review Process ↗FMCSA — Current Exemptions ↗ELDT.live independently creates and reviews its content. We do not present practice questions as official examination questions and do not guarantee a licensing result.