Safety & Inspections • ELDT.LIVE
Brake Safety Week Put 2,134 U.S. Commercial Vehicles Out of Service
CVSA's newly released 2026 results show a 15.1% U.S. brake-related out-of-service rate, with hoses, tubes, air loss, steering-axle components, drums, and rotors among the cited problems.
CVSA released the 2026 results on November 6
The Commercial Vehicle Safety Alliance reported results from Brake Safety Week, conducted August 23–29 across the United States, Canada, and Mexico. Inspectors completed 15,528 commercial-vehicle brake inspections and placed 2,369 vehicles out of service for brake-related violations, a 15.3% overall rate. The figures describe the completed August inspection campaign—not a new inspection week beginning today.
The U.S. out-of-service rate was 15.1%
U.S. jurisdictions conducted 14,165 inspections and placed 2,134 vehicles out of service for brake violations. That means 84.9% of the U.S. vehicles inspected did not have a brake-related out-of-service condition during the campaign. The result should not be treated as a failure rate for the entire national fleet because the inspected vehicles were not presented as a random sample of every CMV on the road.
Most inspections were full Level I checks
Across the three countries, 14,150 inspections—91% of the total—were North American Standard Level I Inspections. This 37-step procedure reviews both driver operating requirements and the vehicle's mechanical condition. During the brake portion, inspectors examine adjustment, slack adjusters, linings, pads, springs, chambers, camshafts, air pressure and loss, tractor protection, tanks, hoses, fittings, parking and emergency braking, and ABS components.
Nearly half of the OOS vehicles met the 20% criterion
CVSA said 1,176 vehicles, or 49.6% of the vehicles placed out of service, had an out-of-service condition on at least 20% of the service brakes on the vehicle or combination. This threshold applies across the brake count for the power unit and attached equipment. One visible defect may therefore be part of a larger combination-level problem that only a complete inspection reveals.
Brake hoses and tubes generated 600 OOS violations
The campaign recorded 600 out-of-service violations involving brake hoses or tubes, 145 for air-loss rate, 92 for steering-axle linings, and 119 for other steering-axle conditions. CVSA also listed 759 other brake-related OOS violations that may include tractor-protection, air-tank, parking, emergency, breakaway, low-air-warning, hydraulic-brake, or electric-brake problems. A vehicle can have more than one violation, so these categories should not be added together as a count of unique trucks.
Drums and rotors were the special focus
Inspectors reported 141 drum and rotor violations, leading to 64 vehicles being placed out of service. The breakdown included 33 broken rotors, 48 rusted rotors, 24 metal-to-metal conditions, and 36 broken drums across air-disc, S-cam, and hydraulic systems. Drivers should report visible cracks, missing pieces, abnormal wear, grinding, pulling, vibration, warning lights, or a change in braking response rather than waiting for a scheduled campaign.
Performance testers found 29 vehicles below the efficiency minimum
Twelve U.S. jurisdictions used performance-based brake testers for 657 inspections. Twenty-nine vehicles, or 4.41%, failed to meet the required 43.5% minimum braking-efficiency rate and were placed out of service. A PBBT result measures overall braking performance; it does not replace the need to inspect individual components and correct mechanical defects.
An out-of-service vehicle must remain stopped until repaired
A brake-related out-of-service order is not a warning that permits the driver to finish the load. The vehicle or combination must not be operated until the condition is corrected and the applicable release requirements are satisfied. Drivers should follow the inspector's instructions, notify dispatch and maintenance, preserve the inspection report, and avoid attempting brake work unless they are qualified and authorized.
Carriers retain year-round maintenance responsibility
Federal rules require motor carriers to systematically inspect, repair, and maintain vehicles under their control and keep parts and accessories in safe operating condition. Brake inspection, maintenance, service, and repair must be performed by personnel who meet the applicable qualifications. A current annual inspection sticker does not guarantee that brakes remain safe between inspections, and a successful roadside inspection does not replace preventive maintenance.
A practical pre-dispatch response
Drivers should complete the carrier's brake checks, listen for air leaks, watch air-pressure build and warning devices, confirm expected brake response, inspect accessible hoses and components, and report defects before movement. Maintenance teams should use the campaign data to review recurring hose damage, air loss, steering-axle conditions, drum and rotor wear, adjustment practices, and repair documentation. CVSA scheduled the next Brake Safety Week for April 18–24, 2027, but the operating standard applies every day.
Educational summaries help you prepare, but official FMCSA and state licensing sources remain the authority for current requirements.
Official sources
CVSA — 2026 Brake Safety Week Results ↗CVSA — Brake Safety Campaign Results ↗FMCSA Motor Carrier Safety Planner — Vehicle Maintenance Violations ↗49 CFR 396.3 — Inspection, Repair, and Maintenance ↗49 CFR 396.25 — Brake Inspector Qualifications ↗ELDT.live independently creates and reviews its content. We do not present practice questions as official examination questions and do not guarantee a licensing result.